Repair Acer Aspire 5740/5340 series laptop

How to disassemble Acer Aspire 5740/5340 series laptop



In this guide I explain how to disassemble Acer Aspire 5740/5340 series laptop.
I’ll walk through the entire laptop base disassembly and remove the motherboard.
Main laptop disassembly steps:
STEP 2-5: Removing laptop hard drive, memory and DVD drive.
STEP 6-11: Removing laptop keyboard.
STEP 12-17: Removing display assembly.
STEP 18-22: Removing top cover assembly.
STEP 23-30: Removing laptop motherboard. Accessing cooling fan and DC jack.

STEP 1.
First of all, make sure the laptop is turned off and battery removed.



STEP 2.
Remove screws securing the hard drive and memory covers on the bottom of the laptop.
Lift up and remove both covers
.


STEP 3.
Both memory slots are located on the bottom of the laptop.
Acer Aspire 5740 series laptop can take up to 8GB RAM total (up to 4GB module in each slot).
Memory specs: PC3-8500 DDR3-1066 204pin SDRAM SODIMM.
This laptop supports Dual-Channel SDRAM support. In order to run it in Dual-Channel mode you must have two identical memory modules in both slots.
I’ll leave both memory modules connected to the motherboard.
Remove one screw securing the hard drive. Slide the hard drive to the shown direction to disconnect it from the motherboard.



STEP 4.
Lift up and remove the hard drive.
Acer Aspire 5740/5340 series laptop has a regular 2.5″ SATA hard drive installed. You can replace it with any large capacity 2.5″ SATA hard drive or SSD
.


STEP 5.
Pull DVD drive from the laptop and remove it.
The DVD drive was secured by one of the screws we removed in the step  2
.


STEP 6.
Carefully lift up the keyboard bezel with a small screwdriver.
Do not move the cover to far from the laptop because the media button board (attached to the cover) still connected to the motherboard.
Turn the keyboard cover upside down
.


STEP 7.
Here you can see the media button board which is attached to the keyboard cover.
Before you can remove the cover it’s necessary to unlock the connector and release the cable
.


On the following picture the connector shown in the locked position.
Lift up the brown locking tab with your fingernail. It will open up at a 90 degree angle.
NOTE: the locking tab must stay attached to the connector base
.


On the following picture the same connector shown in the unlocked position.
Now you can pull cable from the connector.
After you release the cable you can remove the keyboard cover from the laptop
.


STEP 8.
The keyboard secured by three locking latches on the top



Push each latch with a small screwdriver and lift up the keyboard
.


STEP 9.
After all three latches are unlocked you can lift up the keyboard and place it upside down on the palmrest.
Be careful, the keyboard still attached to the motherboard
.


STEP 10.
Disconnect the keyboard cable using the same technique as in the step 7.



STEP 11.
After you disconnected the keyboard cable from the motherboard you can remove the keyboard.
Do you need a new replacement keyboard for Acer Aspire 5740 laptop? You can find it here
.


STEP 12.
In the following six steps I’ll show how to remove the display assembly.
In order to do that we’ll have to disconnect the wireless card antenna cables first.



STEP 13.
Turn the laptop upside down and disconnect two antenna cables from the wireless card.
You can leave the wireless card connected to the motherboard.



STEP 14.
Pull both antenna cables though the opening in the top cover.
Un-route both cables.



STEP 15.
Remove two screws securing display hinges on the bottom of the laptop
.


STEP 16.
Disconnect video cable from the motherboard.
Remove two screws securing display hinges.



STEP 17.
Lift up and remove the display assembly.



STEP 18.
Remove all screw from the bottom of the laptop (I could have missed one or two on this picture, so check all screws carefully).



STEP 19.
Disconnect the following cables from the motherboard:
1. Touchpad cable.
2. Touchpad button board cable.
3. Left speaker cable.
4. Media button board cable.
Disconnect cables 1, 2 and 4 same way you disconnected cable in the step 7.
Update: there are three screws securing the top cover on the top. I forgot to show them. Don’t forget to remove this screws. I’ll fix the picture soon.



STEP 20.
Disconnect the left speaker cable from the motherboard
.


STEP 21.
Start separating the top cover assembly from the laptop base
.


STEP 22.
Remove the top cover assembly.


On the other side of the top cover assembly you can access the left speaker, touchpad and touchpad button board
.


STEP 23.
After the top cover assembly removed you can access the motherboard, CMOS battery (replaceable), modem card and USB board
.


STEP 24.
Remove one screw securing the modem card.
Lift up the modem card and disconnect it from the motherboard
.


STEP 25.
Disconnect the right speaker cable from the motherboard (upper arrow).
Disconnect the USB board cable from the motherboard (lower arrow).
Remove one screw securing the motherboard.



STEP 26.
Make sure the SD dummy card (or SD card) removed from the card reader
.


STEP 27.
Start removing the motherboard from the laptop base as it shown on the following picture
.


STEP 28.
The motherboard removed
.


STEP 29.
The cooling fan assembly attached to the bottom side of the motherboard.
You can buy a new replacement fan for Acer Aspire 5740 series laptop here.



STEP 30.
Acer Aspire 5740/5340 series laptop has DC power jack soldered to the motherboard.
If the jack fails, you’ll have to de-solder it from the motherboard and replace with a new one.



This disassembly guide might fit some other models in the Acer Aspire line. If it works for your laptop, please mention the model number in the following comments.

Sumber;www.InsideMyLaptop.com

Tidak ada komentar:

Posting Komentar